Self-Propelled Ferry version 1.0 for Spintires: MudRunner (v18/03/06)

Recommendations for using the ferry:
1. The media.xml file (in the archive) is necessary to keep the ferry afloat (cars sink).

2. To load a car onto the ferry, drive it into the port all the way,
lower the ramp (key 4),
at the same time the ramp’s protrusion must fit into the red rectangle of the port.
It is not recommended to transport 2 heavy (loaded) cars at once – there may be problems controlling the ferry!

3. The safe sailing zone is limited by buoys,
I do not recommend "landing" on the shore in an unauthorized place –
you will lose both the car and possibly the ferry!

4. For mappers: place the port slightly above the water level (the ferry ramp with a loaded car can catch on the concrete of the port, and the ferry will not move).

5. I recommend making vertical, fairly high shores on the map – contact with a gentle shore causes the ferry to flood!

6. When placing the ferry on the map in the editor (trucks), you need to disable ground snapping and place the ferry on the water surface (so it does not float up from the bottom of the reservoir)!

In the archive: ferry (in X-files – it might be possible to put it in WS for someone).
port (in X-files)
buoy (in X-files)
+ the Media.xml file is extremely necessary to keep the ferry on the water surface!

The ferry model is from the internet, modified in 3ds Max and exported to the game – Vlad_sve

It will not be on Steam due to some additional files required for the ferry!